Snow on a Front Range roof rarely sits still. A sunny January afternoon can melt the south slope down to bare shingle, and by dark that water is refreezing wherever it stopped moving. Then it happens again the next day. Those freeze and thaw cycles push a lot more water through your gutters in midwinter than most people expect, and they do it slowly, at night, when nothing is draining well.

The easiest way to handle gutter maintenance for a Colorado winter is to follow that water. Start where it leaves the shingles, end where it soaks into the ground, and check each spot where it can get stuck.

Step 1: The roof edge

Meltwater runs down the shingles and reaches the eave. There it should drop off a strip of bent metal flashing called drip edge and fall straight into the gutter.

When drip edge is missing, or the gutter hangs too low or too far back, water curls under the shingle edge and runs down behind the gutter instead. It soaks the fascia board. In cold weather it freezes into icicles hanging from the back of the gutter rather than the front lip, and that's the giveaway you can spot from the driveway. Dark streaks or peeling paint on the fascia tell the same story.

In the Town of Castle Rock, a roof replacement has to include ice and water barrier and drip edge at the eaves and rakes, so newer re-roofs there should have it. Older roofs elsewhere may not. If the fascia has gone soft, that wood needs attention before any gutter gets rehung on it, and our roof repair crews handle edge and fascia damage along with the shingles above it.

Step 2: Inside the trough

Fall leaves, pine needles and shingle granules don't leave on their own. Packed wet debris acts like a little dam. Water pools behind it, freezes solid overnight, and the next afternoon's melt has nowhere to go but over the front edge or, worse, over the back toward the fascia.

Ideally the trough gets cleaned before the first hard freeze. If it's already January and the gutter is full of ice, resist the urge to chip at it with a hammer or ice pick. Aluminum punctures easily and the seams crack. Wait for a warm afternoon, use a ladder with a standoff so you're not leaning on the gutter itself, and scoop out what's loose with a gloved hand or a plastic scoop.

One thing worth noticing while you're up there: a thick layer of shingle granules in the trough can mean the shingles are wearing. Not always a crisis. Worth a look, though.

Field Note

An icy ladder on frozen ground is a bad combination. If the gutters need attention and the base of the ladder won't sit flat on dry footing, leave it for a thaw day or call someone with the right setup. No clogged gutter is worth a fall.

Step 3: Along the run

A gutter isn't level. It needs a slight fall toward each outlet so water keeps moving, and the gutter manufacturer publishes the slope it wants for its product. When a section sags, or was hung flat to begin with, water collects in the low spot and freezes into a long log of ice.

That ice is heavy, and it works on the hangers. Hidden hangers screwed into the fascia usually hold. Older spike and ferrule installs tend to back out a little with every freeze, until one day a whole section is tipping forward.

Things you can check from the ground or a short ladder:

  • Water still sitting in the gutter a day after a melt
  • A wavy line when you sight down the gutter from one end
  • A gap opening between the back of the gutter and the fascia
  • Drips from seams and corners rather than from the downspout

A sagging section can often be re-pitched and rehung. If the run is dented, leaking at every seam or simply undersized for the roof above it, our gutter installation and replacement page covers what a new system involves.

Step 4: The outlet and the downspout

The hole where the trough drains into the downspout is the narrowest point on the whole path. It freezes first, especially on a north-facing wall that never sees sun. The elbows at the top of the downspout catch whatever debris got past the trough.

Hail adds a problem people don't connect to winter. The I-25 corridor through Douglas County is one of the most hail-prone stretches of the Front Range, and a summer storm can leave downspouts dented or partly crushed. A pinched downspout catches ice the way a kinked hose catches a clog.

Tap the downspout with your knuckles at a few heights. A hollow ring is good. A dull thud means it's packed with ice or debris. And don't pour hot water down a frozen downspout when it's below freezing outside; it just refreezes a few feet lower.

Step 5: The extension, and where meltwater should end up

This is where most winter water trouble actually shows up. A downspout that dumps right at the foundation sends meltwater into the loose backfill against your basement or crawlspace wall. One that empties across a sidewalk, driveway or front step makes a sheet of ice by morning.

Meltwater should be carried away from the house and released onto ground that slopes away from the foundation, somewhere nobody walks and not onto a neighbor's lot. If you live in an HOA community, check whether the association has rules about where downspouts can discharge.

Flip-up extensions get left up after mowing season, and snow shovels crush them. Buried drain lines have their own failure: if the pop-up emitter at the far end is under a snowbank, the whole pipe can freeze back toward the house. Kick the snow off the emitter after a storm.

Gutter guards, honestly

Guards do one job well. They keep leaves, pine needles and larger debris out of the trough, which cuts down on fall cleanings, particularly under evergreens.

They don't stop ice. Some designs hold a cap of snow on top that melts and refreezes on the guard surface, and then water sheets right over the front edge. Fine-mesh styles can clog with shingle granules and seed pods and need an occasional brushing. A guard won't fix bad pitch, loose hangers or a missing drip edge either. We'd rather tell you which runs on your house would benefit than sell guards for every foot of gutter.

When the ice is really coming from the attic

Here's the pattern to watch for: thick ice building in the gutters during a stretch when the air never climbed above freezing. Sun didn't melt that snow. Your house did.

Heat escaping into the attic warms the roof deck, snow melts from underneath, and the water runs down to the cold overhang at the eave and freezes. The ice grows back up the roof into a dam, and the next round of meltwater backs up under the shingles and into the soffit or ceiling. The gutter isn't causing any of this. It's just where the evidence piles up.

Field Note

Look at your roof the morning after a snowfall. Bare patches over heated rooms while the rest of the roof is still white, or icicles bunched over one bathroom or one set of recessed lights, point to heat loss from that spot.

The usual causes are thin attic insulation, air leaking up around bath fans, can lights and the attic hatch, and soffit vents blocked by insulation. Heat cable on the eaves treats the symptom. The fix is in the attic, and finding it means looking there, which is part of how we approach roof and drone inspections. Ours are free, and if the roof itself is fine we'll say so. Call Verity Roofing & Exteriors at 303-500-1667 from our shop in Castle Rock, and we'll trace your meltwater from the ridge to the yard.